HP P2000

HP P2000 G3 MSA System CLI Reference Guide 107
reset disk-error-statistics
Description Resets error statistics for all or specified disks. Statistics that are reset include:
• Number of SMART events recorded
• Number of I/O timeouts accessing the disk
• Number of times the disk did not respond
• Number of attempts by the controllers to spin up the disk
• Number of media errors (errors generated by the disk as specified by its manufacturer)
• Number of non-media errors (errors generated by the controllers or by the disk and not
categorized as media errors)
• Number of block reassignments
• Number of bad blocks found
To reset other disk statistics, use the reset controller-statistics command.
Syntax
reset disk-error-statistics [disks]
Parameters disks
Optional. IDs of the disks to reset statistics for. For disk syntax, see Command syntax on page 21. If
this parameter is omitted, statistics are reset for all disks.
Example Reset error statistics for disks 1.1 and 2.1:
# reset disk-error-statistics 1.1,2.1
Success: Command completed successfully.
See also • reset all-statistics
• reset controller-statistics
• reset disk-statistics
• reset host-port-statistics
• reset vdisk-statistics
• reset volume-statistics
• show disk-statistics
• show disks