288 XML API basetype properties
advanced-settings-table
Properties
Table 9 advanced-settings-table properties
Name Type Description
background-
scrub
string Shows whether disks in vdisks are automatically checked for disk defects to
ensure system health.
• Disabled: Background vdisk scrub is disabled.
• Enabled: Background vdisk scrub is enabled. This is the default.
background-
scrub-numeric
string Numeric equivalents for background-scrub values.
• 0: Disabled
• 1: Enabled
background-
scrub-interval
uint16 Shows the interval in hours between background vdisk scrub finishing and
starting again. The default is 24 hours.
partner-
firmware-
upgrade
string Shows whether component firmware versions are monitored and will be
automatically upgraded on the partner controller.
• Disabled: Partner firmware upgrade is disabled.
• Enabled: Partner firmware upgrade is enabled. This is the default.
partner-
firmware-
upgrade-numeric
string Numeric equivalents for partner-firmware-upgrade values.
• 0: Disabled
• 1: Enabled
utility-
priority
string Priority at which data-redundancy utilities, such as vdisk verify and reconstruct,
run with respect to I/O operations competing for the system's processors. (This
does not affect vdisk background scrub, which always runs at “background”
priority.)
• High: Utilities have higher priority than host I/O. Use when your highest
priority is to return the system to a fully fault-tolerant state. This can cause
heavy I/O to be slower than normal. This is the default.
• Medium: Utility performance is balanced with host I/O performance.
• Low: Utilities run at a slower rate with minimal effect on host I/O. Use when
streaming data without interruption, such as for a web server, is more
important than data redundancy.
utility-
priority-
numeric
string Numeric equivalents for utility-priority values.
• 0: High
• 1: Medium
• 2: Low
smart string Shows whether Self-Monitoring Analysis and Reporting Technology is enabled
or disabled for disks.
• Disabled: SMART is disabled for all disks.
• Enabled: SMART is enabled for all disks. This is the default.
• Detect-Only: Each new disk inserted in the system retains its current
SMART setting.
smart-numeric string Numeric equivalents for smart values.
• 0: Detect-Only
• 1: Enabled
• 2: Disabled
To Next Page
Loading...
