180 Alphabetical list of commands
show controller-date
Description Shows the system’s current date and time. Values are shown in Coordinated Universal Time (UTC).
Syntax
show controller-date
Output Controller Date
Date and time in the format year-month-day hour:minutes:seconds.
Time-Zone Offset
The system’s time zone as an offset in hours and minutes from UTC. This is shown only if NTP is
enabled.
Example Show the date and time on a system that is using NTP:
# show controller-date
Controller Date: 2009-06-09 10:58:04
Time-Zone Offset: -6
Basetypes • time-settings-table
• status
See also • set controller-date
• show ntp-status
To Next Page
Loading...
