HP P2000 Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 41
convert master-to-std
Description Converts a specified master volume into a standard volume; that is, it disables the volume from
accepting snapshots. If the specified volume has associated snapshots, you must delete the snapshots
before converting the volume.
Syntax
convert master-to-std master-volume
Parameters master-volume
Name or serial number of the master volume to convert. For volume syntax, see Command syntax on
page 21.
Example Convert a master volume having no snapshots to a standard volume:
# convert master-to-std MV1
Success: Command completed successfully. - The conversion of a master volume to
a standard volume completed.
See also • delete all-snapshots
• show master-volumes

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure