HP P2000 Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 75
delete remote-system
Description Deletes the persistent association with a remote system.
After establishing replication to a remote system, if you choose to delete the remote system you can
safely do so without affecting replications. However, because the remote system's name and IP
address will no longer appear in user interfaces, record this information before deleting the remote
system so that you can access it at a later time, such as to delete old replication images or for
disaster recovery.
Syntax
delete remote-system system
Parameters system
Name or network-port IP address of the remote system.
Example Delete remote system System2:
# delete remote-system System2
Success: Command deleted successfully. (System2) - The remote system was
deleted.
See also • create remote-system
• remote
• set remote-system
• show remote-systems

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure