HP P2000 Reference Guide

144 Alphabetical list of commands
set led
Description Changes the state of the identification LED on a specified disk or enclosure. For a disk this affects the
Fault/UID LED. For an enclosure this affects the UID LED. LEDs are described in the user guide.
Syntax To set a disk LED:
set led
disk ID
enable|disable|on|off
To set an enclosure LED:
set led
enclosure ID
enable|disable|on|off
Parameters disk ID
The disk to locate. For disk syntax, see Command syntax on page 21.
enclosure ID
The enclosure to locate.
enable|disable|on|off
Specifies to set or unset the LED.
Example Identify disk 5 in the first enclosure:
# set led disk 1.5 on
Success: Command completed successfully. - Enabling identification LED for disk
1.5...
Stop identifying the first enclosure:
# set led enclosure 1 off
Success: Disabling identification LED for enclosure 1...

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure