HP P2000 Reference Guide

30 Alphabetical list of commands
abort replication
Description Aborts the current replication operation on the specified replication volume. The current replication
may be running or suspended. This command must be issued on the system that owns the secondary
volume.
Syntax
abort replication
[set replication-set]
replication-volume
Parameters set replication-set
Optional. Name or serial number of the replication set.
replication-volume
Name or serial number of the replication volume. If the name is not unique across replication sets,
specify the set parameter.
Example Abort replication on replication volume MV1:
# abort replication MV1
Success: Replication Aborted.
See also • resume replication
• suspend replication
• show replication-sets
• show replication-volumes

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure