HP P2000 Reference Guide

348 XML API basetype properties
iscsi-parameters
Properties
Example
# show iscsi-parameters
...
<OBJECT basetype="iscsi-parameters" name="iscsi-parameter" oid="1" format="pairs">
<PROPERTY name="chap" type="string">Disabled</PROPERTY>
<PROPERTY name="chap-numeric" type="string">0</PROPERTY>
<PROPERTY name="jumbo-frames" type="string">Disabled</PROPERTY>
<PROPERTY name="jumbo-frames-numeric" type="string">0</PROPERTY>
<PROPERTY name="isns" type="string">Disabled</PROPERTY>
<PROPERTY name="isns-numeric" type="string">0</PROPERTY>
<PROPERTY name="isns-ip" type="string">0.0.0.0</PROPERTY>
Table 38 iscsi-parameters properties
Name Type Description
chap string Shows whether Challenge-Handshake Authentication Protocol (CHAP) is
enabled.
• Enabled: CHAP is enabled.
• Disabled: CHAP is disabled. This is the default.
chap-numeric string Numeric equivalents for chap values.
• 0: Disabled
• 1: Enabled
jumbo-frames string Shows whether support for jumbo frames is enabled.
• Enabled: Jumbo-frame support is enabled.
• Disabled: Jumbo-frame support is disabled. This is the default.
jumbo-frames-
numeric
string Numeric equivalents for jumbo-frames values.
• 0: Disabled
• 1: Enabled
isns string Shows whether support for Internet Storage Name Service (iSNS) is enabled.
• Enabled: iSNS is enabled.
• Disabled: iSNS is disabled. This is the default.
isns-numeric string Numeric equivalents for isns values.
• 0: Disabled
• 1: Enabled
isns-ip string Address of the iSNS server. The default address is all zeroes.
isns-alt-ip string Address of the alternate iSNS server. The default address is all zeroes.
iscsi-speed string iSCSI host port link speed.
• auto: The proper speed is auto-negotiated. This is the default.
• 1Gbps: The speed is forced to 1 Gbit/sec, overriding a downshift that can
occur during auto-negotiation with 1-Gbit/sec HBAs. This setting does not
apply to 10-Gbit/sec HBAs.
iscsi-speed-
numeric
string Numeric equivalents for iscsi-speed values.
• 0: auto
• 1: 1Gbps
iscsi-ip-
version
uint8 iSCSI IP version.
• 4: iSCSI host port addresses use IPv4 format. This is the default.
• 6: iSCSI host port addresses use IPv6 format.

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure