HP P2000

HP P2000 G3 MSA System CLI Reference Guide 131
set debug-log-parameters
Description For use by or with direction from a service technician.
Sets the types of debug messages to include in the Storage Controller debug log.
Syntax
set debug-log-parameters message-type+|- [...]
Parameters message-type+|-
One of the following message types, followed by a plus (+) to enable or a minus (-) to disable
inclusion in the log:
• awt: Auto-write-through cache triggers debug messages
• bkcfg: Internal configuration debug messages
• cache: Cache debug messages
• capi: Internal Configuration API debug messages
• capi2: Internal Configuration API tracing debug messages
• disk: Disk interface debug messages
• dms: Snapshot feature debug messages
• emp: Enclosure Management Processor debug messages
• fo: Failover/recovery debug messages
• fruid: FRU ID debug messages
• hb: Not used
• host: Host interface debug messages
• init: Not used
• ioa: I/O interface driver debug messages (standard)
• iob: I/O interface driver debug messages (resource counts)
• ioc: I/O interface driver debug messages (upper layer, verbose)
• iod: I/O interface driver debug messages (lower layer, verbose)
• mem: Internal memory debug messages
• misc: Internal debug messages
• msg: Inter-controller message debug messages
• mui: Internal service interface debug messages
• ps: Not used
• raid: RAID debug messages
• rcm: Removable-component manager debug messages
• res2: Internal debug messages
• resmgr: Reservation Manager debug messages
Example Include RAID and cache messages, exclude EMP messages, and leave other message types
unchanged:
# set debug-log-parameters raid+ cache+ emp-
Success: Command completed successfully. - Debug-log parameters were changed.
See also • show debug-log-parameters