218 Alphabetical list of commands
show ports
Description Shows information about host ports on both controllers. This command shows the same information
as the show host-parameters command.
Syntax
show ports
Output Ports
Controller ID and port number
Media
• FC(P): Fibre Channel Point-to-Point
• FC(L): Fibre Channel-Arbitrated Loop
• FC(-): Not applicable, as when the port is disconnected
• SAS: Serial Attached SCSI
• iSCSI: Internet SCSI
Target ID
Port WWN or IQN
Status
Whether the port is operational, has a problem, or is disconnected
Speed (A)
Actual host-port link speed, or blank if not applicable.
Speed (C)
Configured host-port link speed:
• FC: Auto, 8Gb, 4Gb, or 2Gb (Gbit/sec)
• iSCSI: Auto or 1Gb (Gbit/sec)
• Blank if not applicable
Topo (C)
FC and SAS only. Configured topology
Width
SAS only. Number of SAS lanes in the port.
PID
FC and SAS only. Primary ID, or blank if not applicable.
IP-Ver
iSCSI only. IP version: IPv4 or IPv6.
PIP
iSCSI only. Primary IP address.
PIP-Gateway
iSCSI only. Primary gateway IP address.
PIP-Netmask
iSCSI only. Primary subnet mask IP address.
MAC
iSCSI only. Unique Media Access Control (MAC) hardware address, also called the physical
address.
SIP
iSCSI only. Secondary IP address. This field is only displayed during failover.
SIP-Gateway
iSCSI only. Secondary gateway IP address. This field is only displayed during failover.
To Next Page
Loading...
Need help?
General
