HP P2000 G3 MSA System CLI Reference Guide 151
set protocols
Description Enables or disables management services and protocols.
Syntax
set protocols
[debug enabled|disabled|on|off]
[ftp enabled|disabled|on|off]
[http enabled|disabled|on|off]
[https enabled|disabled|on|off]
[ses enabled|disabled|on|off]
[smis enabled|disabled|on|off]
[snmp enabled|disabled|on|off]
[ssh enabled|disabled|on|off]
[telnet enabled|disabled|on|off]
Parameters debug enabled|disabled|on|off
Optional. Enables or disables the Telnet debug port.
ftp enabled|disabled|on|off
Optional. Enables or disables the expert interface for updating firmware.
http enabled|disabled|on|off
Optional. Enables or disables the standard SMU web server.
https enabled|disabled|on|off
Optional. Enables or disables the secure SMU web server.
ses enabled|disabled|on|off
Optional. Enables or disables the in-band SCSI Enclosure Management Services interface.
smis enabled|disabled|on|off
Optional. Enables or disables the Storage Management Initiative Specification interface (SMI-S)
interface, which allows SMI-S clients to communicate with each controller’s embedded SMI-S
provider.
snmp enabled|disabled|on|off
Optional. Enables or disables the Simple Network Management Protocol interface. Disabling this
option disables all SNMP requests to the MIB and disables SNMP traps. To configure SNMP traps
use the set snmp-parameters command.
ssh enabled|disabled|on|off
Optional. Enables or disables the secure shell CLI.
telnet enabled|disabled|on|off
Optional. Enables or disables the standard CLI.
Example Disable unsecure HTTP connections and enable FTP:
# set protocols http disabled ftp enabled
Success: Command completed successfully.
See also • show protocols
To Next Page
Loading...
Need help?
General
