282 Alphabetical list of commands
verify remote-link
Description Verifies host-port links between the local system and a specified remote system. All link paths, or only
paths having a specified link type, between the two systems are tested. The remote system must
already have been added by using the create remote-system command.For replication purposes, this
tests the links to be used for replication from one system to another system. To verify bidirectional
communication, run this command from the primary system to the secondary system, and then from
the secondary system to the primary system.
Syntax
verify remote-link
remote-system system
[link-type FC|iSCSI|ALL]
Parameters remote-system system
The remote system’s name or the IP address of one of its controller network ports.
link-type FC|iSCSI|ALL
Optional. Specifies the type of host-port links to verify:
• FC: Verify FC-to-FC links only.
• iSCSI: Verify iSCSI-to-iSCSI links only.
• ALL: Verify all FC-to-FC and iSCSI-to-iSCSI links.
If this parameter is omitted, all links are verified.
Output Port
Port ID on the local system.
Type
• FC: FC port.
• iSCSI: iSCSI port.
• Offline: Port is disconnected.
Remote Links
IDs of linked ports on the remote system.
Example Verify all links between two FC-only systems:
# verify remote-link remote-system System2
Port Type Remote Links
---------------------------------------
A2 FC A2,B2
B2 FC A2,B2
---------------------------------------
Verify only iSCSI links between two FC/iSCSI systems:
# verify remote-link remote-system System2 link-type iSCSI
Port Type Remote Links
---------------------------------------
A4 iSCSI A4,B4
B4 iSCSI A4,B4
---------------------------------------
Basetypes • remote-links
See also • show remote-systems
• verify links
To Next Page
Loading...
Need help?
General
