262 Alphabetical list of commands
show vdisks
Description Shows information for all or specified vdisks.
Syntax
show vdisks [vdisks]
Parameters vdisks
Optional. Names or serial numbers of the vdisks to show information about. For vdisk syntax, see
Command syntax on page 21.
Output Name
Vdisk name
Size
Vdisk size
Free
Vdisk free space
Own
Either the preferred owner during normal operation or the partner controller when the preferred
owner is offline
Pref
Controller that owns the vdisk and its volumes during normal operation
RAID
Vdisk RAID level
Disks
Number of disks in the vdisk
Spr
Number of spares assigned to the vdisk
Chk
• For RAID levels except NRAID, RAID 1, and RAID 50, the configured chunk size for the vdisk.
• For NRAID and RAID 1, chunk-size has no meaning and is therefore shown as not applicable
(N/A).
• For RAID 50, the vdisk chunk size calculated as: configured-chunk-size x (subvdisk-members - 1).
For a vdisk configured to use 32-KB chunk size and 4-disk subvdisks, the value would be 96k
(32KB x 3).
Status
• CRIT: The vdisk is online, however some disks are down and the vdisk is not fault-tolerant
• FTDN: The vdisk is online and fault-tolerant, however some of the disks are down
• FTOL: The vdisk is online and fault-tolerant
• OFFL: The vdisk is offline because it is using offline initialization, or because disks are down and
data may be lost
• QTCR: The vdisk is in a critical state and has been quarantined because some disks are missing
• QTOF: The vdisk is offline and has been quarantined because some disks are missing
• STOP: The vdisk is stopped.
• UNKN: Unknown.
• UP: The vdisk is online and does not have fault-tolerant attributes
To Next Page
Loading...
Need help?
General
