HP P2000 G3 MSA System CLI Reference Guide 119
set advanced-settings
Description Sets advanced system configuration options.
Syntax
set advanced-settings
[auto-write-back enabled|disabled|on|off]
[background-disk-scrub enabled|disabled|on|off]
[background-scrub enabled|disabled|on|off]
[background-scrub-interval interval]
[compact-flash-failure enabled|disabled|on|off]
[controller-failure enabled|disabled|on|off]
[dynamic-spares enabled|disabled|on|off]
[emp-poll-rate rate]
[fan-failure enabled|disabled|on|off]
[host-cache-control enabled|disabled|on|off]
[missing-lun-response notready|illegal]
[partner-firmware-upgrade enabled|disabled|on|off]
[partner-notify enabled|disabled|on|off]
[power-supply-failure enabled|disabled|on|off]
[smart enabled|disabled|on|off|detect-only]
[super-cap-failure enabled|disabled|on|off]
[sync-cache-mode immediate|flush]
[temperature-exceeded enabled|disabled|on|off]
[utility-priority low|medium|high]
[spin-down enabled|disabled|on|off]
[spin-down-delay delay]
Parameters auto-write-back enabled|disabled|on|off
Optional. Sets whether the cache mode automatically changes to write-back after the trigger
condition is cleared.
background-disk-scrub enabled|disabled|on|off
Optional. Sets whether disks that are not in vdisks are automatically checked for disk defects to
ensure system health. The interval between background disk scrub finishing and starting again is 24
hours.
background-scrub enabled|disabled|on|off
Optional. Sets whether disks in vdisks are automatically checked for disk defects to ensure system
health. The interval between background vdisk scrub finishing and starting again is specified by the
background-scrub-interval parameter.
background-scrub-interval interval
Optional. Sets the interval between background vdisk scrub finishing and starting again, from
1–360 hours. The default is 24 hours.
compact-flash-failure enabled|disabled|on|off
Optional. Sets whether the cache policy automatically changes to write-through when CompactFlash
memory fails.
controller-failure enabled|disabled|on|off
Optional. Sets whether the cache policy automatically changes to write-through when a controller
fails. The default is disabled.
dynamic-spares enabled|disabled|on|off
Optional. Sets whether the storage system will automatically designate an available compatible disk
as a spare to replace a failed disk in a vdisk. A compatible disk has enough capacity to replace the
failed disk and is the same type (SAS or SATA).
emp-poll-rate rate
Optional. Sets the interval at which the storage system polls the EC (EMP) for status changes, from
5–3600 seconds. The default is 5 seconds.
To Next Page
Loading...
Need help?
General
