140 Alphabetical list of commands
On a system with FC ports, set the link speed to 4 Gbit/sec for ports A1 and B1; set controller A
ports to request loop ID 5 and controller B ports to request loop ID 32; and suppress the confirmation
prompt:
# set host-parameters speed 4g ports a1,b1 fibre-loop-id 5,32 noprompt
Info: Changes to FC loop ids will not take effect until the affected Storage
Controller is restarted.
Success: Command completed successfully. - The host parameters were changed
successfully
On a system with iSCSI ports, for port A3 change the IP address:
# set host-parameters ip 10.134.50.6 port a3 iscsi-ip-version ipv4
WARNING: This change will take effect immediately. Changes may affect access to
data. Are you sure? yes
Success: Command completed successfully. - The host parameters were changed
successfully
Specify that iSCSI ports will use IPv6 addressing:
# set host-parameters iscsi-ip-version ipv6
Success: Command completed successfully. - iSCSI parameter(s) were changed
successfully.
See also • restart
• set iscsi-parameters
• show host-parameters
To Next Page
Loading...
