HP P2000 G3 MSA System CLI Reference Guide 195
Output • Date and time when the event was logged
• Event code identifying the type of event to help diagnose problems; for example, [181]
• Event ID prefixed by A or B, indicating which controller logged the event; for example, #A123
• Model, serial number, and ID of the controller module that logged the event
• Severity:
• CRITICAL: A failure occurred that may cause a controller to shut down. Correct the problem
immediately.
• ERROR: A failure occurred that may affect data integrity or system stability. Correct the
problem as soon as possible.
• WARNING: A problem occurred that may affect system stability but not data integrity. Evaluate
the problem and correct it if necessary.
• INFORMATIONAL: A configuration or state change occurred, or a problem occurred that the
system corrected. No action is required.
• Event-specific message giving details about the event
Example Show the last two events:
# show events last 2
Show the last three non-Informational events:
# show events last 3 error
Show all events from April 30 2009 at 11:59:00 p.m. through May 2 2009 at 11:59:00 a.m.:
# show events from 043009235900 to 050209115900
Show a range of events logged by controller A:
# show events from-event a100 to-event a123
Basetypes • events
• status
See also • clear events
• set snmp-parameters
• show snmp-parameters
To Next Page
Loading...
Need help?
General
