HP P2000 Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 257
Mode
• new-snapshot: Replicate a new snapshot of the primary volume.
• last-snapshot: Replicate the most recent existing snapshot of the primary volume.
Last Created
Name of the last volume created by the task, or blank
Last Used Snapshot
For a task whose replication mode is last-snapshot, the name of the last snapshot used for
replication; otherwise, N/A
For an EnableDSD task:
Task Name
Task name, which must be taskDSDresume
Task Type
EnableDSD
Status
• Uninitialized: Task is not yet ready to run
• Ready: Task is ready to run
• Active: Task is running
• Error: Task has an error
• Invalid: Task is invalid
Task State
Current step of the task; always Start
Error Message
Message if an error occurred while processing the task, or blank
For a DisableDSD task:
Task Name
Task name, which must be taskDSDsuspend
Task Type
DisableDSD
Status
• Uninitialized: Task is not yet ready to run
• Ready: Task is ready to run
• Active: Task is running
• Error: Task has an error
• Invalid: Task is invalid
Task State
Current step of the task; always Start
Error Message
Message if an error occurred while processing the task, or blank

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure