HP P2000 G3 MSA System CLI Reference Guide 309
Example
# show controllers
...
<OBJECT basetype="controllers" name="controllers" oid="1" format="pairs">
<PROPERTY name="durable-id" type="string">controller_a</PROPERTY>
<PROPERTY name="controller-id" type="string">A</PROPERTY>
<PROPERTY name="controller-id-numeric" type="string">1</PROPERTY>
<PROPERTY name="serial-number" type="string">SN</PROPERTY>
mfg-location string City, state/province, and country where the FRU was manufactured.
mfg-vendor-id string JEDEC ID of the FRU manufacturer.
health string • OK
• Degraded
• Fault
• Unknown
• N/A
health-numeric string Numeric equivalents for health values.
• 0: OK
• 1: Degraded
• 2: Fault
• 3: Unknown
• 4: N/A
health-reason string More information about the health value.
health-blame string If health is not OK, this indicates whether this component or one of its
subcomponents is to blame.
• none: This component and its subcomponents are ok.
• self: This component has a problem.
• child: A subcomponent has a problem.
• both: Both this component and at least one subcomponent have a problem.
health-blame-
numeric
string Numeric equivalents for health-blame values.
• 0: none
• 1: self
• 2: child
• 3: both
position string Position of the controller in the enclosure.
• Top: The controller is in the top slot.
• Bottom: The controller is in the bottom slot.
position-
numeric
string Numeric equivalents for position values.
• 0: Top
• 1: Bottom
phy-isolation string Shows whether the automatic disabling of SAS expander PHYs having high error
counts is enabled or disabled for this controller.
• Enabled: PHY fault isolation is enabled. This is the default.
• Disabled: PHY fault isolation is disabled.
phy-isolation-
numeric
string Numeric equivalents for phy-isolation values.
•
0: Enabled
• 1: Disabled
Table 18 controllers properties (continued)
Name Type Description
To Next Page
Loading...
Need help?
General
