5-17
General System Configuration
Modifying System Information
CLI: Setting the System Name
CLI Commands Used in This Section
The following example shows using the hostname <hostname> syntax to set
the name of the system.
Note Enter management commands, one per line.
To display the configured system name, use the show system-information
command.
Command Syntax CLI Reference Page
hostname <hostname> 9-19
show system-information 9-27
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# hostname ProCurve-AP530
ProCurve Access Point 530(config)#
To Next Page
Loading...
