9-117
Command Line Reference
Wireless Interface Commands
Example
show ssid
This command provides information about the Service Sets/Basic Service Sets
of the radio(s) on the device. If in a radio or WLAN context, displays informa-
tion only about the radio in context. This is functionally equivalent to the show
wlan command.
Syntax
show ssid [<name>] [ statistics ] [ all ]
• name - Displays detailed information about the specified WLAN (SSID/
BSS).
• statistics - Display traffic counters in addition to information about the
WLAN (SSID/BSS).
ProCurve Access Point 530# show radios
------------------------------------------------------------
Radio Status Base MAC Address Mode Channel TX-Power
-----------------------------------------------------------------------
1 Disabled 00:14:C2:A5:22:E0 802.11g 1 - Auto 0 dBm
2 Disabled 00:14:C2:A5:22:F0 802.11a 36 - Auto 0 dBm
ProCurve Access Point 530# show radio 1
Description Radio 1 - 802.11g
Base MAC 00:14:C2:A7:11:A0 Status Enabled
Mode 802.11g Channel-Policy Auto
Channel 1 WLANs Supported 16
Preamble long CTS Protection Enabled
Slot-time short Beacon-Interval(K-us) 100
Max Power(dBm) 16.0 Power Reduction(dB) 0
Antenna Mode diversity Antenna(s) In Use internal
RTS-Threshold 2347 Fragment-Threshold 2346
WMM QoS Disabled Inactivity Timeout 1800
Max Stations 256
Rate-Limiting (Disabled)
Rate-Limit(packets/second) 50 Burst-Limit(packets/second) 75
AP-Detection (Enabled)
Periodic Scan Duration(ms) 30 Periodic Scan Interval(sec) 10
List Max Entries 255 List Expiration Time(sec) 3600
ProCurve Access Point 530#
To Next Page
Loading...
