9-79
Command Line Reference
Web Authentication Commands
Web Authentication Commands
The commands described in this section are used to enable and configure Web
Authentication (Web-Auth) in the Access Point 530.
Command Function Mode Page
Global
[no] web-auth Enables 802.1X authentication using a
Web-browser interface on the access
point.
IC-R-
WLAN
9-82
[no] web-auth starting-ip-address <ip-
address> <subnet-mask>
Specifies the first IP address and
subnet mask that define the pool of
temporary IP addresses used for initial
Web-Auth connections.
GC 9-80
web-auth lease-time <ip-address> Specifies the period in seconds of the
IP lease for the pool of temporary Web-
Auth addresses.
GC 9-80
[no] web-auth guest-username
<username>
Specifies the username that will be
used for Guest user logins using Web-
Auth.
GC 9-81
[no] web-auth guest-password
<password>
Specifies the password that will be
used for Guest user logins using Web-
Auth.
GC 9-81
show web-auth
Displays the current Web-Auth settings. MC 9-85
Per WLAN
[no] web-auth guest-login Enables or disables Web-Auth for Guest
users on the selected WLAN.
IC-R-
WLAN
9-82
[no] web-auth username-
login Enables or disables Web-Auth for
Registered users on the selected
WLAN.
IC-R-
WLAN
9-82
[no] web-auth redirect-url Specifies the URL the user is redirected
to following successful Web
Authentication.
IC-R-
WLAN
9-82
web-auth retry-limit <retries> Specifies the number of failed login
attempts (from 1 to 9) a user may make
before logins are refused by the access
point. Default is 3 attempts.
IC-R-
WLAN
9-82
[no] web-auth default-login-page Enables or disables the default field
values for the Login screen.
IC-R-
WLAN
9-83
To Next Page
Loading...
