HP ProCurve 530 NA (J8986A)

9-45
Command Line Reference
Network Management Application Commands
show snmp-server
This command displays information about the configuration and status of the
SNMP server on this device.
Syntax
show snmp-server
Default Setting
None
Command Mode
Manger Exec
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# show snmp-server
SNMP Server Settings
---------------------------------------------------------------------------
SNMP Status Enabled
SNMP Port 161
Community (ro) public
Community (rw) private
Location 2FS17
Contact RBolero
No SNMP trap destinations are currently configured.
hpWlanAdHocNetworkDetected Enabled hpWlanApDetectionUpdate Enabled
hpWlanRadioAntennaUpdate Enabled hpWlanButtonUpdate Enabled
hpWlanClientAssociation Enabled hpWlanApInterfaceUpdate Enabled
hpWlanClientDeAuthentication Enabled hpWlanClientAuthentication Enabled
hpWlanClientRequestFailure Enabled hpWlanClientReAssociation Enabled
hpWlanDot1XAuthNotInitiated Enabled hpWlanDot1XAuthFailure Enabled
hpWlanLocalMacAuthClientFailure Enabled hpWlanDot1XAuthSuccess Enabled
hpWlanLocalMacAuthClientSuccess Enabled hpWlanMgmtAccessUpdate Enabled
hpWlanPossibleNeighborApDetected Enabled hpWlanMgmtVlanIdUpdate Enabled
hpWlanRadiusAccountingUpdate Enabled hpWlanRadiusServerFailover Enabled
hpWlanRemoteMacAddrAuthFailure Enabled hpWlanSystemUp Enabled
hpWlanRemoteMacAddrAuthSuccess Enabled hpWlanSystemDown Enabled
hpWlanSystemFWUpgradeStatus Enabled hpWlanVlanUntaggedUpdate Enabled
hpWlanSystemConfigFileTransfer Enabled
ProCurve Access Point 530(config)#