9-81
Command Line Reference
Web Authentication Commands
Example
web-auth (Global Guest User)
These commands configure the global Guest credentials used by Web-Auth on
the device. The no version of the command clears the saved value.
Syntax
[no] web-auth guest-username <username>
[no] web-auth guest-password <password>
• username - Specifies the username used for all Guest users.
• password - Specifies the password used for all Guest users.
Command Mode
Global Configuration
Example
ProCurve Access Point 530(config)# web-auth starting-ip-
address 192.168.0.1 255.255.240.0
ProCurve Access Point 530(config)# web-auth lease-time 60
ProCurve Access Point 530(config)# show web-auth
Temporary Address Pool Start 192.168.0.1
Subnet 255.255.240.0
Lease time (secs.) 60
Guest Username lbg_guest
Guest Password lbgpassword
ProCurve Access Point 530(config)#
ProCurve Access Point 530(config)# web-auth guest-username
lbg_guest
ProCurve Access Point 530(config)# web-auth guest-password
lbg_password
ProCurve Access Point 530(config)#
show web-auth
Temporary Address Pool Start 192.168.0.1
Subnet 255.255.240.0
Lease time (secs.) 60
Guest Username lbg_guest
Guest Username lbg_password
ProCurve Access Point 530(config)#
To Next Page
Loading...
