HP ProCurve 530 NA (J8986A)

9-141
Command Line Reference
Adaptive Tx Power Control Commands
Example
atpc avoid-other-aps
This command enables and disables the Avoid Other APs function.
Syntax
[no] atpc avoid-other-aps
• no - Disables the Avoid Other APs function on the selected radio.
Default Setting
Disabled
Command Mode
Interface Configuration (Radio)
Command Usage
• When this setting is enabled, adapts to all neighboring APs; RF Group
Names and SSIDs are ignored. When this setting is disabled, uses RF
Group Name or SSIDs to determine which APs to accommodate.
Example
atpc rf-group-name
This command sets the name used to group APs for Adaptive Transmit Power
Control.
Syntax
[no] atpc rf-group-name <group-name>
• no - Clears the RF Group Name on the selected radio.
• group-name - Specifies the name of the group to which the radio will
belong.
ProCurve Access Point 530(radio1)# atpc
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530(radio1)# atpc avoid-other-aps
ProCurve Access Point 530(radio1)#