HP ProCurve 530 NA (J8986A)

5-46
General System Configuration
Enabling System Logging
CLI: Setting Logging Parameters
CLI Commands Used in This Section
The following example shows how to set an IP address for the receiving server
using the logging command.
The following example shows the settings.
Command Syntax CLI Reference Page
log 9-30
[no] logging <host >[port] 9-31
show debug 9-32
show logging 9-32
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# logging 10.1.0.3
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# show debug
Debug Logging:
Syslog Relay 10.1.0.3 (port 514)
ProCurve Access Point 530(config)#