HP ProCurve 530 NA (J8986A)

8-23
Special Features
Wireless Distribution System (WDS) and Spanning Tree Protocol (STP)
CLI: Configuring WDS Links
CLI Commands Used in This Section
Using the CLI to Enable WDS. This example enables the WDS link.
Using the CLI to Set the WDS SSID. This command sets the WDS SSID
string for this WDS link and establishes a preshared key.
Command CLI Reference Page
enable 9-158
radio-used <1 |2 > 9-159
remote-mac <mac> 9-160
wds-ssid <ssid> (required when using WPA over WDS) 9-159
wep-key-ascii 9-162
wep-key <key> 9-161
wep-key-length <64|128> 9-162
wpa-pre-shared-key <key> 9-163
show wds & show wds<wds_name> 9-160
ProCurve Access Point 530(config)# interface wds1
ProCurve Access Point 530(wds1)# enable
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface wds1
ProCurve Access Point 530(wds1)# wds-ssid marge
ProCurve Access Point 530(wds1)# wpa-pre-shared-key
goodsecret
ProCurve Access Point 530(wds1)#