6-27
Wireless Interface Configuration
Modifying Antenna Settings
CLI: Setting the Transmit Power Reduction and Antenna
Parameters
CLI Commands Used in This Section
The following example shows how to set the transmit power reduction value,
establish an external antenna, and set the mode to Single on the access point.
The default mode is set to Diversity.
Command Syntax CLI Reference Page
tx-power-reduction <value> 9-114
antenna <external | internal> 9-105
antenna mode <diversity | single> 9-105
show radio 9-116
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# tx-power-reduction 5
ProCurve Access Point 530(radio1)# antenna external
ProCurve Access Point 530(radio1)# antenna mode single
To Next Page
Loading...
