9-19
Command Line Reference
System Management Commands
Default Setting
For NA units, preset to US
Command Mode
Global Configuration
Command Usage
• The access point’s Country Code must be set before the radio can be
enabled.
• After a Country Code has been set and the system rebooted, the
country command is no longer available from the CLI. If you need to
change the Country Code, the access point configuration must be
reset to its default values by using the erase-startup-config
command, or by pressing the reset button and clear buttons simulta-
neously, see Appendix A, “Resets the configuration back to factory defaults.” on
page A-17.
Example
hostname
This command sets the system hostname.
Syntax
hostname <hostname>
Cuba CU Korea, Democratic
People Republic Of
KP Philippines PH Yemen YE
Cyprus CY Korea, Republic Of KR Poland PL Zambia ZM
Czech Republic CZ Kuwait KW Portugal PT Zimbabwe ZW
Denmark DK Kyrgyzstan KG Puerto Rico PR
Dominican Republic DO Lao People’s Democratic
Republic
LA Qatar QA
Ecuador EC Latvia LV Romania RO
Country Code Country Code Country Code Country Code
ProCurve Access Point 530# country gb
ProCurve Access Point 530#
To Next Page
Loading...
Need help?
General
