HP ProCurve 530 NA (J8986A)

5-61
General System Configuration
Configuring VLAN Support
CLI: Enabling VLAN Support
CLI Commands Used in This Section
The following example shows how to establish a management VLAN ID.
The following example shows how to set an untagged VLAN ID in the interface
context.
The following example shows how to set a tagged VLAN at the WLAN context.
Command Syntax CLI Reference Page
vlan 9-145
[no] untagged-vlan <vid> 9-146
management-vlan <vid> 9-146
show wlans 9-117
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# management-vlan 9
ProCurve Access Point 530(ethernet)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# untagged-vlan 9
ProCurve Access Point 530(ethernet)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# vlan 3
ProCurve Access Point 530(radio1-wlan1)#