7-52
Wireless Security Configuration
Configuring MAC Address Authentication
Clearing the MAC Lockout list. The following example shows how to
remove all MAC addresses from the current MAC Lockout list.
CLI: Configuring Client/Station Deauthentication
The client/station deauthentication command deauth-mac deauthenticates a
specific device from the access point. All sessions that match the MAC address
are immediately disconnected from all WLANs on all radios.
Note Unlike MAC Lockout, a deauthenticated client/station is not blocked from re-
authenticating.
CLI Commands Used in This Section
Deauthenticating a device from the access point. The following exam-
ple shows how to force a client device to deauthenticate from the access point.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# lockout-mac clear all
2 MAC addresses removed from lockout list
ProCurve Access Point 530(config)# show lockout-mac
No MAC addresses in lockout list.
ProCurve Access Point 530(config)#
Command Syntax CLI Reference Page
deauth-mac <mac_address> 9-78
ProCurve Access Point 530# deauth-mac 00:d0:59:c8:62:dd
ProCurve Access Point 530#
To Next Page
Loading...
