HP ProCurve 530 NA (J8986A)

9-137
Command Line Reference
Neighbor AP Detection Commands
Command Usage
• While the access point scans a channel for neighbor APs, wireless
stations will not be able to connect to the access point. Therefore,
frequent scanning or scans of a long duration will degrade the access
point’s performance. If more extensive scanning is required, use the
dedicated scanning mode.
Example
ap-detection duration
This command sets the duration of channel scanning for the background
scanning detection of nearby access points.
Syntax
ap-detection duration <value>
• value - The length of time in milliseconds. Range: 5-30.
Default Setting
30 ms
Command Mode
Radio Interface Configuration
Example
ap-detection expire-time
This command sets the amount of time that a dedicated AP will remain on the
detected AP-list after its last beacon is received.
Syntax
ap-detection expire-time <value>
• value - The length of time in seconds. Range: 1-604800.
Default Setting
ProCurve Access Point 530(radio1)# ap-detection dedicated
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530(radio1)# ap-detection duration 10
ProCurve Access Point 530(radio1)#