9-21
Command Line Reference
System Management Commands
password manager
This command sets the password for entering the Manager Exec level.
Syntax
password manager <password>
• password - A text string to establish security for entry into the Manager
Exec level.
Note: The password is case sensitive and must be at least 1 character
and at most 32 characters long. However, only the first 8 characters
of the password are used; character number 9 and above are ignored
at log in.
Default Setting
admin
Command Mode
Global Configuration
Example
buttons
This command enables the ability to clear the password(s) and/or configura-
tion(s) via the buttons on the device. The no command disables this ability.
Syntax
buttons <custom-reset | factory-reset | password-reset | system-reset>
• custom-reset - Enables the ability to reset this device to the custom-
default configuration via the buttons. The no version of the command
disables this devices ability to reset this device to the custom-default
configuration via the buttons.
• factory-reset - Enables the ability to reset this device to the factory-
default configuration via the buttons. The no version of the command
disables this devices ability to reset this device to the factory-default
configuration via the buttons. The no buttons factory-reset command
will not work if the serial console is already disabled (e.g." no console"
has been executed).
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# password manager admin
To Next Page
Loading...
