9-161
Command Line Reference
Wireless Distribution System (WDS)
Command Mode
WDS Interface Configuration
Example
wep-key (wds)
This command defines the wep-keys used for data encryption on an WDS
interface.
Syntax
wep-key <key>
• key - Sets the character string for security. The number of characters
depend on the number of characters required for each WEP key
depends on the Key Length and Key Type settings:
– If Key Length is 40 bits and the Key Type is "ASCII", then each
WEP key must be five (5) characters long.
– If Key Length is 40 bits and Key Type is "Hex", then each WEP key
must be 10 characters long.
– If Key Length is 104 bits and Key Type is "ASCII", then each WEP
Key must be 13 characters long.
ProCurve Access Point 530(wds1)# show wds 1
WDS # 1
Description WDSLINK
Status Enabled Use Radio 1
Local MAC 00:14:03:A2:4F:DE Remote MAC 00:0D:9D:C6:98:7E
STP State forwarding WDS SSID marge
Security Type no-security (from WLAN 1) WEP Key Type
hex
WEP Key not set WEP Key Size
128bit
WPA Key goodsecret
Bytes Rx 0 Bytes Tx 0
Packets Rx 0 Packets Tx 0
Compressed Rx 0 Compressed Tx 0
Mcast packets Rx 0 Carrier errors Tx 0
Dropped Rx packets 0 Dropped Tx packets 0
FIFO overflows Rx 0 FIFO overflows Tx 0
Frame errors Rx 0 Packet collisions Tx 0
Total Rx errors 0 Total Tx errors 0
ProCurve Access Point 530(wds1)#
To Next Page
Loading...
