HP ProCurve 530 NA (J8986A)

9-22
Command Line Reference
System Management Commands
• password-reset - Enables the ability to reset the password(s) on this
device via the buttons. The no version of the command disables this
devices ability to reset the password(s) on this device via the buttons.
• system-reset - Enables the ability to reset the system via the buttons.
The no version of the command disables this devices ability to reset
the system via the buttons.
Default Setting
Enabled
Command Mode
Global Configuration
Example
This example shows how to disable all the push button capabilities.
cli-confirmation
This command enables all CLI confirmation dialog prompts on the device. The
no command disables this ability.
Syntax
cli-confirmation
no cli-confirmation
Default Setting
Enabled
Command Mode
Global Configuration
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# no buttons custom-reset
ProCurve Access Point 530(config)# no buttons factory-reset
ProCurve Access Point 530(config)# no buttons password-reset
ProCurve Access Point 530(config)# no buttons system-reset
ProCurve Access Point 530(config)#