9-14
Command Line Reference
General Commands
This example shows how to perform a warm reboot of the system:
show
This command displays the status of access point settings.
Syntax
show [basic-rate | buttons | config | console | copy | custom-default | debug |
detected-ap | dot11 | filters | interfaces | ip | lldp | logging | mac-auth-local | qos
| radios | radius-local | running-config | snmp-server | sntp | ssh | ssid | stations
| supported-rate | system-information | time | version | wlans | wds ]
• basic-rate - Shows advertised transmission rates for this device. See
“show basic-rate” on page 9-121.
• buttons - Shows current status of the buttons on this device. See “show
buttons” on page 9-25.
• config - Shows the startup configuration file of this device. See “show
config” on page 9-56.
•
console - Shows serial console configuration/status on this device. See
“show console” on page 9-26.
• copy - Shows status of the last copy operation (ftp/scp/tftp). See “show
copy” on page 9-57.
• custom-default -Shows custom default configuration file of device. See
“show custom-default” on page 9-58.
• debug - Shows debug-related information on this device. See “show
debug” on page 9-32.
• detected-ap - Shows detected neighboring wireless network details. See
“show detected-ap” on page 9-139.
• filters - Shows settings for traffic/security filters on this device. See
“show filters” on page 9-89.
• interfaces - Shows information about the interfaces on this device. See
“show interface” on page 9-97.
• ip - Shows the current IP configuration on this device. See “show ip” on
page 9-96.
• lldp - Shows Link Layer Discovery Protocol (LLDP) details. See “show
lldp” on page 9-49.
ProCurve Access Point 530# reload
Device will be rebooted, do you want to continue [y/n]?y
Do you want to save the current configuration [y/n]?n
Connection to host lost.
To Next Page
Loading...
