HP ProCurve 530 NA (J8986A)

9-48
Command Line Reference
Network Management Application Commands
show snmpv3
This command displays the current SNMPv3 settings on the access point.
Syntax
show snmpv3
Default Setting
Disabled
Command Mode
Manager Exec
Example
Related Commands
snmpv3 enable (page 9-46)
snmpv3 user-name (page 9-47)
lldp
This command enables Link Layer Discovery Protocol (LLDP) service on the
device. The no version of the command disables LLDP on the device.
Syntax
lldp
no lldp
Default
Enabled
ProCurve Access Point 530# show snmpv3
SNMPv3: Enabled
SNMP engine ID: 00:00:00:0b:00:00:00:14:c2:a5:09:8c
SNMPv3 user accounts:
Username Auth. Protocol Privacy Protocol
----------------------------------------------
ltulina MD5 AES
afanto None None
tjames MD5 None
ProCurve Access Point 530#