9-146
Command Line Reference
VLAN Commands
Note You must not use the same VLAN ID for both a statically configured VLAN and
for a VLAN dynamically configured by a RADIUS server policy. If you dynam-
ically assign a VLAN that has already been statically assigned to a VLAN or to
the management VLAN or untagged VLAN, the dynamic authentication will
fail and will continue trying to authenticate.
untagged-vlan
This untagged-vlan command sets the specified vlan number to be treated as
untagged by the AP, device-wide (globally). The no version of the command
sets any untagged VLAN to become tagged.
Syntax
untagged-vlan <vid>
no untagged-vlan
• vid - The identifier must be a number between 1 and 4094.
Default Setting
vlan-1 untagged
Command Mode
Ethernet Interface Configuration
Example
management-vlan
This command configures the VLAN ID for the management interfaces (Web
UI, SNMP, Telnet, etc.). The management-vlan is for the "remote" or "network"
management of the AP.
Syntax
management-vlan <vid>
• vid - The VLAN identifier to use for management.
Default Setting
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# untagged-vlan 9
ProCurve Access Point 530(ethernet)#
To Next Page
Loading...
Need help?
General
