9-121
Command Line Reference
Wireless Interface Commands
Example: show wlan1
Related Commands
show ssid (page 9-117)
show basic-rate
This command displays information about advertised transmission rates for
this device.
Syntax
show basic rate
Default
N/A
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# show wlan1
------------------------------------------------------------
WLAN # 1 on Radio 1
Description Radio 1 - WLAN 1
Status Enabled SSID SSID 1
VLAN 1 - Untagged BSSID 00:14:C2:A7:11:A0
DTIM Period 2
Security Type no-security (No Sec.) Closed System Disabled
MAC Auth Mode local deny-list only MAC Auth List not set
Authentication open-system only WEP Key Type ascii
WEP Key 1 akshjsnensitk WEP Key Size 128bit
WEP Key 2 not set Default Key WEP Key 1
WEP Key 3 not set
WEP Key 4 not set
WPA or WPA2 WPA and WPA2 WPA Cipher TKIP only
WPA Pre-auth. Disabled WPA Key Format ascii
WPA ASCII Key abcdefghijklmnop
WPA Hex Key not set
Web Authentication
Status Disabled Retry Limit 3
Username/Password Login Enabled Guest Login Enabled
Redirect URL www.procurve.com
Default Login Page Enabled
Default Login Failed Page Enabled
Default Welcome Page Enabled
-- MORE --, next page: Space, next line: Enter, quit: Control-C
To Next Page
Loading...
