HP ProCurve 530 NA (J8986A)

9-56
Command Line Reference
Flash/File Commands
show config
This command displays the startup configuration on the device.
Syntax
show config
Default Setting
N/A
Command Mode
Manager Exec
Example
ProCurve Access Point 530# show config
<?xml version="1.0"?>
<config>
<interface name="wlan0wds1">
<type>wds</type>
<status>down</status>
<wds-security-policy>no-security</wds-security-policy>
<wep-key-length>104</wep-key-length>
<radio>wlan1</radio>
<wds-ssid>WDS SSID 2</wds-ssid>
<wep-key-ascii>no</wep-key-ascii>
<wds-wpa-psk-format>ascii</wds-wpa-psk-format>
<description>Wireless Distribution System - Link 2</
description>
</interface>
<interface name="wlan0wds4">
<type>wds</type>
<status>down</status>
<wds-security-policy>no-security</wds-security-policy>
<wep-key-length>104</wep-key-length>
<radio>wlan1</radio>
<wds-ssid>WDS SSID 5</wds-ssid>
<wep-key-ascii>no</wep-key-ascii>
<wds-wpa-psk-format>ascii</wds-wpa-psk-format>
<description>Wireless Distribution System - Link 5</
description>
</interface>
......