6-21
Wireless Interface Configuration
Configuring the Radio
7. Deselect rate set values (11, 5.5, 2, and 1) and select rate set values (24,
12, and 6) using the Basic options.
8. Select
[Update] to set the advanced radio parameters.
CLI: Configuring Radio Settings
CLI Commands Used in This Section
Note You must set the country code before configuring the radio settings. These
basic settings affect the radio channels and values that are available for other
parameters. See “Setting the Country Code” on page 6-4. Use the write mem
command to save the setting.
Configuring One Radio. The following example details how to enable one
radio and configure specific radio parameters on the access point.
Note Enter radio commands one line at a time.
.
Command Syntax CLI Reference Page
description <string> 9-116
[no] basic-rate <value> 9-106
beacon-interval <value> 9-108
fragmentation-thresh <value> 9-111
rts-threshold <value> 9-113
show stations 9-122
show radio <radio> 9-116
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# description “Radio 1 -
802.11g”
ProCurve Access Point 530(radio1)# beacon-interval 102
ProCurve Access Point 530(radio1)# fragmentation-thresh 1024
ProCurve Access Point 530(radio1)# rts-threshold 2000
To Next Page
Loading...
