HP ProCurve 530 NA (J8986A)

6-22
Wireless Interface Configuration
Configuring the Radio
The following example uses the show radio <radio> command to display this
access point’s radio parameter details.
The following example uses the show stations command to display
connected stations to the access points.
ProCurve Access Point 530# show radio 1
Description Radio 1 - 802.11g
Base MAC 00:14:C2:A7:11:A0 Status Enabled
Mode 802.11g Channel-Policy Auto
Channel 11 WLANs Supported 16
Preamble long CTS Protection Enabled
Slot-time short Beacon-Interval(K-us) 100
Max Power(dBm) 0.0 Power Reduction(dB) 0
Antenna Mode diversity Antenna(s) In Use internal
RTS-Threshold 2347 Fragment-Threshold 2346
WMM QoS Disabled Inactivity Timeout 1800
Max Stations 256
Rate-Limiting (Disabled)
Rate-Limit(packets/second) 50 Burst-Limit(packets/second) 75
AP-Detection (Enabled)
Periodic Scan Duration(ms) 30 Periodic Scan Interval(sec) 10
List Max Entries 255 List Expiration Time(sec) 3600
ProCurve Access Point 530#
ProCurve Access Point 530# show stations
Station On WLAN (radio index/WLAN index) Auth. Assoc. Fwd.
------------------------------------------------------------
00:0b:cd:5c:3b:da GJ SSID 1 (1/1) Yes - n/a
00:0f:66:16:7a:77 GJ SSID 1 (2/1) Yes Yes n/a
00:0b:cd:5a:47:64 GJ SSID 1 (2/1) Yes Yes n/a
ProCurve Access Point 530#