HP ProCurve 530 NA (J8986A)

9-37
Command Line Reference
Network Management Application Commands
Network Management Application
Commands
These commands are used to configure Simple Network Management
Protocol (SNMP) and Link Layer Discovery Protocol which defines standards
for facilities network management..
Command Function Mode Page
SNMP
[no] snmp-server community
<comm> restricted |
unrestricted
Sets up the private community access string to
permit access to SNMP commands
GC 9-38
[no] snmp-server host
<host><comm>
Sets the system location string. GC 9-40
[no] snmp-server contact
<contact>
Sets the contact string. GC 9-40
snmp-server port <port> Sets the SNMP server port number. GC 9-42
[no] snmp-server trap <trap> Enables and disables SNMP traps. GC 9-43
show snmp-server Displays the status of SNMP communications. MC 9-45
SNMPv3
[no] snmpv3 enable Enables and disables SNMPv3 functions on the
access point.
GC 9-46
[no] snmpv3 user-name <name>
[auth <md5 | sha>
<password>] [priv <des |
aes> <password>]
Adds and removes SNMPv3 users on the access
point.
GC 9-47
show snmpv3 Displays current SNMPv3 settings on the access
point.
GC 9-48
LLDP
[no] lldp Enables Link Layer Discovery Protocol service on
the device.
GC 9-48
show lldp Displays the Link Layer Discovery Protocol service
status on the device.
GC 9-48