HP ProCurve 530 NA (J8986A)

9-49
Command Line Reference
Network Management Application Commands
Command Mode
Global Configuration
Example
show lldp
This command displays the status of the Link Layer Discovery Protocol
(LLDP) service on the device.
Syntax
show lldp
Default
N/A
Command Mode
Global Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# lldp
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# show lldp
LLDP Status Enabled
ProCurve Access Point 530(config)#