9-136
Command Line Reference
Neighbor AP Detection Commands
Neighbor AP Detection Commands
The access point can be configured to periodically scan all radio channels and
find other access points within range. Alternatively, the access point can scan
continuously in a dedicated mode with no stations supported. A database of
nearby access points is maintained where detected APs can be identified.
ap-detection
This command enables the background detection of nearby access points. The
no command disables AP detection by this radio.
Syntax
ap-detection [dedicated]
no ap-detection
• [dedicated] - Dedicate this radio to be used for continuous AP detection.
This radio will not be able to service wireless stations or WDS links
if it is dedicated to AP-detection. The no version of this command is
not available for this parameter.
Default Setting
Disabled
Command Mode
Radio Interface Configuration
Command Function Mode Page
[no] ap-detection
[dedicated]
Enables the periodic or dedicated detection of nearby
access points
IC-R 9-136
ap-detection duration
<value>
Sets the duration of the passive detection of nearby
access points
IC-R 9-137
ap-detection expire-
time <value>
Sets the time a dedicated AP remains on the AP list after
its last received beacon.
IC-R 9-137
ap-detection interval
<value>
Sets the wait time between scans when performing
periodic (passive) scanning.
IC-R 9-138
ap-detection max-
entries <value>
Sets the maximum amount of entries of the detected APs
on the detected AP list.
IC-R 9-138
show detected-ap Shows the current configuration for AP detection MC 9-139
To Next Page
Loading...
