7-24
Wireless Security Configuration
Manual Configuration Using the CLI
Manual Configuration Using the CLI
The following sections show examples of how to use the CLI to view and
configure access point security settings.
NOTE: Security settings using the CLI can only be made for WLANs in the context of
Radio 1. Security settings for each different WLAN are automatically copied
from Radio 1 to Radio 2. The only setting that can be made specifically in the
context of Radio 2 is to enable or disable the entire WLAN on Radio 2.
CLI: Configuring Security Settings
CLI Commands Used in This Section
Command Syntax CLI Reference
Page
security <no-security | static-wep | dynamic-wep | wpa-psk | wpa-802.1x> 9-125
wep-default-key <1| 2| 3| 4> 9-127
[no] wep-key ascii 9-128
wep-key-length <64|128> 9-129
wep-key-<1| 2| 3| 4> <string> 9-129
[no] open-system-authentication 9-130
[no] shared-key authentication 9-131
radius-accounting <primary | secondary> ip <ip> | port <port> | key
<key>
9-65
radius <primary | secondary> 9-67
[no] wpa-allowed 9-131
[no] wpa2-allowed 9-131
wpa-pre-shared-key <key> 9-132
wpa-cipher-tkip 9-133
wpa-cipher-aes 9-133
rsn-preauthentication 9-135
To Next Page
Loading...
