9-101
Command Line Reference
Wireless Interface Commands
radio
This command enters the wireless interface configuration mode for config-
uring parameters for the radio interface.
Syntax
radio <radio_name>
• radio_name - The name used to identify the radio. I.E. 1, 2.
Default Setting
None
Command Mode
Radio Interface Configuration
slot-time Sets the wait time. IC-R 9-113
rts-threshold Sets the packet size threshold at which an RTS must
be sent to the receiving station prior to the sending
station starting communications
IC-R 9-113
tx-power-reduction Adjusts the power of the radio signals transmitted from
the access point.
IC-R 9-114
enable Enables the radio or SSID wireless interfaces. IC-R
IC-R-
WLAN
9-115
disable Disables the radio or SSID wireless interfaces. IC-R
IC-R-
WLAN
9-116
show radio <radio> Shows the status for the wireless interface MC 9-116
show wlan <ssid_index> Displays parameters for the specified SSID interface MC 9-117
show basic-rate Displays the specified basic rate for the interfaces. MC 9-121
show stations Display information about associated wireless stations. MC 9-122
show supported-rate Displays the supported rates for the interfaces. MC 9-123
Command Function Mode Page
To Next Page
Loading...
