9-124
Command Line Reference
Wireless Security Commands
Wireless Security Commands
The commands described in this section configure parameters for wireless
security on SSID interfaces.
Command Function Mode Page
security <no-security | static-
wep | dynamic wep | wpa-psk |
wpa-8021x>
Enables the type of security suite on a SSID
interface.
IC-W-S 9-125
wep-default-key <1| 2| 3| 4> Defines the key index if using the static-wep
security.
IC-W-S 9-127
[no] wep-key
ascii Sets the wep key to an ascii format. IC-W-S 9-128
wep-key-length <64|128> Sets the wep-key-length to either 64 or 128
bits if using the static-wep security.
IC-W-S 9-129
wep-key-<1| 2| 3| 4>
<key>
Defines the up to four security keys, if using
the static-wep security.
IC-W-S 9-129
[no] open-system-authentication Enables or disables open-system
authentication for SSID association.
IC-W-S 9-130
[no] shared-key authentication Enables or disables shared-key authentication
for SSID association.
IC-W-S 9-131
[no] wpa-allowed | [no]
wpa2-
allowed
Enables or disables wireless stations to use
the original WPA and WPA2 on this WLAN.
IC-W-S 9-131
wpa-preshared-key <key> Defines a WPA preshared key. IC-W-S 9-132
wpa-cipher-tkip Enables TKIP for WPA on this WLAN. IC-W-S 9-133
wpa-cipher-aes Enables the Advanced Encryption Algorithm
(AES) for WPA on this WLAN.
IC-W-S 9-133
wpa-psk-ascii Enables ASCII shared key. IC-W-S 9-133
wpa-psk-hex Enables hex shared key. IC-W-S 9-133
rsn-preauthentication Enables WPA2 stations to pre-authenticate on
this WLAN.
IC-W-S 9-135
To Next Page
Loading...
