9-100
Command Line Reference
Wireless Interface Commands
Wireless Interface Commands
The commands described in this section configure global parameters for the
wireless interface.
Command Function Mode Page
radio < 1 | 2 > Enters wireless interface configuration mode. GC 9-101
ssid <ssid> Sets SSID string. IC-R 9-102
description Specifies a human-readable description of this
interface.
IC-R 9-103
closed-system Closes access to stations without a pre-configured
SSID.
IC-R-
WLAN
9-103
mode<value> Sets the radio working mode. IC-R 9-104
antenna < external |
internal >
Sets the antenna on this radio. IC-R 9-105
antenna mode< diversity |
single >
Sets the antenna mode. IC-R 9-105
basic-rate<value> Configures the maximum data rate at which the access
point can transmit traffic.
IC-R 9-106
supported-rate<value> Configures the maximum data rate at which the access
point can transmit traffic.
IC-R 9-107
channel-policy < static |
auto >
Sets the policy on the channel to static or automatic. IC-R 9-107
beacon-interval
<interval>
Configures the rate at which beacon frames are
transmitted from the access point.
IC-R 9-108
dtim-period Configures the rate at which stations in sleep mode
must wake up to receive broadcast/multicast
transmissions
IC-R 9-109
max-stations Configures the maximum number of stations that can
be associated with the access point at the same time
IC-R 9-110
preamble Sets the length of signal preamble. IC-R 9-110
[no] protected-mode Sets the 802.11 b/g CTS protection mode for this radio. IC-R 9-111
fragmentation-thresh Configures the minimum packet size that can be
fragmented
IC-R 9-111
inactivity-timeout Configures the inactivity time. IC-R 9-112
To Next Page
Loading...
