HP ProCurve 530 NA (J8986A)

9-23
Command Line Reference
System Management Commands
Example
console
This command enables the serial console on the access point. The no version
disables the serial console on the access point. The no console command will
not work if the factory reset button is already disabled (e.g." no buttons
factory-reset" has been executed).
Syntax
console
no console
Default Setting
Enabled
Command Mode
Global Configuration
Example
telnet
This command enables remote Telnet access. The no version disables remote
Telnet access to this device.
Syntax
telnet
no telnet
Default Setting
Enabled
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# cli-confirmation
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# console
ProCurve Access Point 530(config)#