6-25
Wireless Interface Configuration
Modifying Antenna Settings
Web: Setting the Antenna Type and Antenna Mode
The Radio – Advanced Settings pop-up window, shown in Figure 6-9, enables
you to configure the following settings for adjusting the transmit power limits:
■ Antenna Type: The type of radio antenna utilized by this access point.
(The default is Internal.)
■ Antenna Mode: The mode of radio antenna utilized by this access point.
(The default is Diversity.)
■ [Update]: Updates the antenna type and antenna mode parameters.
Note Radio 2 must be configured to an external antenna if Radio 2 is configured to
either the IEEE 802.11b or 802.11g mode, The Radio 2 internal antenna must
be configured to the IEEE 802.11a mode. See “Radio Configuration Summary Table” on
page 6-6.
Figure 6-9. Setting Antenna Parameters
To Modify the Antenna Parameters:
1. Select Network Setup > Radio.
2. Click Status On to enable the radio.
3. Click the Edit button for Advanced Settings. A pop-up window for Advanced
Settings opens (see Figure 6-9).
4. To set the radio to use an internal or external antenna, select Internal or
External Antenna Type.
5. To set the radio to use a specific antenna mode, select Diversity or Single
Antenna Mode.
To Next Page
Loading...
